Cloud LM-2 Series Manual de instalación Pagina 29

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 36
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 28
29
TROUBLESHOOTING
Problem B
Pool is green and no chlorine reading
Chlorine is still considered the most effective way of destroying algae and bacteria in your
pool water. A chlorine residual of 1 to 3 ppm is considered desirable.
REMEDY:
Superchlorinate or manually shock the pool with sodium hypochlorite. This will raise
the chlorine residual to a very high level for a short period of time, and reduce chlorine
demand.
1. Superchlorinate with the Clearwater chlorinator:
i) Backwash the filter.
ii) Adjust the pH to within the range 7.2 – 7.6. See ‘Tips on Water Chemistry’.
iii) Press the button marked ‘Super Chlorinate’. The Clearwater automatically increases
its output and runs for approx. 24 hours of pool pump time.
iv) After 24 hours, backwash the filter.
v) Re-adjust the pH to 7.2 – 7.6.
vi) Check the chlorine reading.
vii) If the chlorine reading is too low, repeat steps (iii) to (vi) until the chlorine reading is
satisfactory.
2. Manually shock with chlorine or oxidizing agents:
i) Backwash the filter.
ii) Adjust the pH to within the range 7.2 – 7.6 (See ‘Tips on Water Chemistry’).
iii) Follow instructions of superchlorinating product being employed.
iv) After shock dosing, re-adjust the pH to within the range of 7.2 – 7.6 and check
the chlorine level before using the pool. The chlorine residual should be 1 – 3 ppm.
Vista de pagina 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

Comentarios a estos manuales

Sin comentarios