Cloud LM-2 Series Manual de instalación descargar pdf (Pagina 13)

CONTROLLER OPERATION

Controller Operation

Startup

When switched on, the chlorinator must go through an initialization sequence; this is indicated by the

amber LED being illuminated. After a short period the LED will switch off and the chlorinator will

begin ‘normal’ operation.

First time startup

When the chlorinator is connected to the mains for the first time and the initialization sequence has

been completed the chlorinator defaults to the ‘zero output’ state. The user can then select the

desired output level.

Output Settings

The battery backup will hold the output settings in memory when the unit is turned off, unless the

setting was changed less than one minute before turning off.

Reversing Polarity

The battery backup will remember the polarity reversal time.

Controller Interface

Because the LM2 chlorinator is capable of being connected to various controllers, it is necessary to

select which controller the LM2 is to be connected to. This is done as follows:

1. Make a suitable cable connection.

2. Turn the power to the LM2 ‘ON’ via the controller.

3. HOLD the LM2 “service” button down for at least 20 seconds (see illustration below). The Super

Chlorinate LED will flash momentarily, either 1, 2 or 3 times, then will go out for approximately 5

seconds.

4. Continue to hold the “service” button down until the correct number of flashes for the controller

being used is observed. See the controller chart below.

Hidden “Service” Button here

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Sin comentarios

Cloud LM-2 Series Manual de instalación Pagina 13