Cloud LM-2 Series Manual de instalación descargar pdf (Pagina 19)

INDICATOR LIGHTS - WHAT THEY MEAN

Indicator lights: What they mean

Chlorine Output

A series of six lights indicate the chlorine output setting of the power pack. More

lights equals greater chlorine production. Note: This setting does not show the actual

chlorine reading in the pool. Use of a test kit is required to confirm the free chlorine

reading of pool water.

Chlorine Output – Yellow Light Flashing

The yellow (low output) light flashes for a few minutes during cell reversal (cell

self-clean) indicating no output during this time.

Super Chlorinate – Light On

This light indicates that the super chlorinate feature has been selected, it will turn off

when the super chlorinate period has ended.

Super Chlorinate – Light Off

Function not selected.

Add Salt – Light On

The ‘Add Salt’ light will come on at any salt level between 3000ppm and 4000ppm

depending on mains voltage and water temperature (below 18ºC, 65ºF). This is not

a fault but a precaution to ensure the salt level is never too low. (See “Salt: When and

how to add it’). Note: Operating the LM2 at reduced salt levels may shorten the life

of the cell.

Add Salt – Light Off

Indicates that the salt level in the pool is correct.

No Flow – Light On

This indicates insufficient water flow in cell, usually caused by the pump not running.

The chlorine output will also turn off at this time. Do not leave the device on when

the pump is off or when backwashing the filter.

All Lights Off

All lights off indicates the LM2 is turned off. Turn unit on. If lights are still off, check

the resettable fuse and circuit breaker.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Sin comentarios

Cloud LM-2 Series Manual de instalación Pagina 19