Cloud LM-2 Series Guía de instalación descargar pdf (Pagina 6)

LM-2 Installation Guide v1.06

The LM-2’s OUTPUT connector should be connected to the host unit’s FACILITY PORT for the Zone in which it is installed*

with screened Cat 5 cable and shielded RJ45 plugs.

LINK

OUTPUT

LM-2 (UK version illustrated)

100 m max

Connect to

OUTPUT socket

Connect to

FACILITY PORT

Screened

Cat 5 cable

The maximum total Cat 5 cable length should not exceed 100 m. If further modules are being “linked” together (see below),

this gure applies to the overall cable run from the host unit to the “furthest” module in the chain.

IMPORTANT: Because the cables carry low-level audio, only screened Cat 5 should be used, the foil screen of the cable being

bonded to the metal screening can of the plugs. If an LM-2 is being installed in very close proximity to the host unit, it may be

possible to use ready-made screened Cat 5 “patch” cables of short length. In all other situations, shielded RJ45 plugs should be

crimped onto the installed screened Cat 5 cable using the pinout shown below.

PIN USE Cat 5 CORE

1 Audio ‘cold’ phase (-) White + Orange

2 Audio ‘hot’ phase (+) Orange

3 Priority VCA control White + Green

4 +15 V Blue

5 0 V White + Blue

6 -15 V Green

7 Music level control (0 to 10 V) White + Brown

8 Music source select control (0 to 10 V) Brown

SCN Screen for system music controls Connector shell

* There is no reason why the module cannot be connected to the Facility Port of a Zone other than that in which it is installed – though this is likely to be an

unusual installation scenario.













 



1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Cloud LM-2 Series Guía de instalación Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Mezcladores de audio Cloud LM-2 Series