Cloud VTX 4120 Manual de usuario descargar pdf (Pagina 10)

VTX-WM1 Installation Guide v1.010

13. The VTX-WM1 card has an on-board

clock/calendar, which needs to be set

for the Event Log to be meaningful. The

default Current Time will be midnight

on Jan. 1

st

. 2000; click the adjacent Set

button to open the Clock setting

window.

Enter the current date and time in the ve

elds in the format yyyy-mm-dd hh:mm

and click Apply.

14. Click Apply on the Amplier

Properties page to conrm the data

entered.

15. Enter the amplier’s new IP address into

the browser’s URL eld to re-establish

communication with the card. The Home

page will now conrm the Site and

Amplier Names which were entered, and

there will also be a green tick and “OK” in

the amplier’s Network eld to conrm

communication with the new address. The

CloudNET page will also conrm that

the amplier has been designated Server

status.

16. Connect the next amplier’s VTX-WM1

card to the Ethernet switch. Select the

Home page tab, and after a few seconds,

the amplier’s details will be added to

the amplier list. On the CloudNET tab,

you will see that the additional amplier

has a red cross in the Server column

– the rst amplier retains Server status

because the browser is still using its IP

address.

17. The additional amplier will have the

default IP address; this will need to be

changed. Click the Cong tab, and select

the new amplier with its blue button

(it will still be named “Cloud Amplier”).

Then repeat the procedure above, starting

at Step 10.

18. Continue this procedure, adding one

amplier at a time, until all the ampliers

in the system are registered on the

browser. Note each time, that the PC

may take a few moments to recognise

that a VTX-WM1 card has had its address

changed; this is normal.

19. When all the ampliers have been

congured, the Ethernet switch may be

reconnected to the building’s IT network.

It is recommended that access to the

ampliers is re-checked by entering the IP

address of one of them from a computer

elsewhere on the network.

Amplier data – using the GUI

Once the ampliers have been congured,

amplier performance and settings can be

monitored from the web browser of any

computer on the network. To access the

system, enter the IP address of any of the

ampliers into the URL eld of the web

browser. This will show the Home Page, an

example of which is shown below:

The Home Page gives a overview of the entire

system. All ampliers are listed, by the names

that they were given during conguration. The

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios